no-load apparent power

Mira otros diccionarios:

• Power factor — For other uses, see Power factor (pistol). The power factor of an AC electric power system is defined as the ratio of the real power flowing to the load over the apparent power in the circuit,[1][2] and is a dimensionless number between 0 and 1… …   Wikipedia

• Power rating — In electrical engineering, the power rating of a device is a guideline set by the manufacturer as a maximum power to be used with that device. This limit is usually set somewhat lower than the level where the device will be damaged, to allow a… …   Wikipedia

• Power factor —   The ratio of real power (kilowatt) to apparent power kilovolt ampere for any given load and time.   U.S. Dept. of Energy, Energy Information Administration s Energy Glossary   ***   The ratio of the average power and the apparent volt amperes.… …   Energy terms

• Power optimization (EDA) — Power optimization refers to the use of electronic design automation tools to optimize (reduce) the power consumption of a digital design, while preserving the functionality.Introduction and historyThe increasing speed and complexity of today’s… …   Wikipedia

• Power flow study — In power engineering, the power flow study (also known as load flow study) is an important tool involving numerical analysis applied to a power system. Unlike traditional circuit analysis, a power flow study usually uses simplified notation such… …   Wikipedia

• AC power — This article deals with power in AC systems. See Mains electricity for information on utility supplied AC power. Usually hidden from the unaided eye, the blinking of (non incandescent) lighting powered by AC mains is revealed in this motion… …   Wikipedia

• Electric power transmission — Electric transmission redirects here. For vehicle transmissions, see diesel electric transmission. 400 kV high tension transmission lines near Madrid Electric power transmission or high voltage electric transmission is the bulk transfer of… …   Wikipedia

• Maximum power transfer theorem — In electrical engineering, the maximum power transfer theorem states that, to obtain maximum external power from a source with a finite internal resistance, the resistance of the load must be equal to the resistance of the source as viewed from… …   Wikipedia

• Maximum power theorem — In electrical engineering, the maximum power (transfer) theorem states that, to obtain maximum external power from a source with a finite internal resistance, the resistance of the load must be made the same as that of the source. It is claimed… …   Wikipedia

• Wind power forecasting — A wind power forecast corresponds to an estimate of the expected production of one or more wind turbines (referred to as a wind farm) in the near future. By production is often meant available power for wind farm considered (with units kW or MW… …   Wikipedia

• Environmental effects of wind power — Compared to the environmental effects of traditional energy sources, the environmental effects of wind power are relatively minor. Wind power consumes no fuel, and emits no air pollution, unlike fossil fuel power sources. The energy consumed to… …   Wikipedia